As with all H3F rods, the finish is a matte gray. The thread wraps are tight, and you’ll find two SiC stripping guides alongside REC Recoil snake guides. The build quality on the Orvis H3F and H3D series is impeccable. I’ve touched on this in every other review I’ve done of an H3 rod, but I’ll briefly address it here. Given that this is the “F” model as opposed to its more powerful “D” model cousin, that’s pretty impressive. The 9’6″ 6wt H3F has plenty of blank strength to help turn and lift fish. Related Post Congress Gives NRMA Green Light The rods are stout throughout the butt section, but lose any power, stability, and strength in the last few feet of the tip. You notice this a lot on some of the lower-end Euro Nymphing rods, if you’re paying attention. And six inches is more than enough to make a normally great rod feel a bit wobbly. Honestly, six inches doesn’t feel like a huge difference in length, but as anyone can attest, length matters. The 9’6″ 6wt Orvis H3F isn’t a Scott or Winston by any means, but it’ll get the job done. For fishing pre-runoff hatches in low, crystal-clear water, that sort of delicacy is an absolute must. While I’d never call this rod a delicate dry fly tool, it is remarkably adept at soft, accurate presentations. That’s some serious power that comes in handy when hatches are sporadic and fish are wary. I rarely, if ever, had to false cast with this rod. Multiple times while using this rod to fish small dries in Oregon this March, I needed to pick up 50 or 60 feet of line and recast quickly. ![]() Angler Ryan McCullough casting the Orvis H3F to wary brown trout. The 9’6″ 6wt Orvis H3F handled both lines flawlessly, though it mended the DT line better (as should be expected). I used a Cortland 444 Classic Peach DT6F and the Orvis Power Taper WF6F on a Hardy Princess and Orvis Mirage reel, respectively. I usually test rods out with various lines, because a good line can make all the difference in rod performance. It rockets line wherever you cast, and with whichever line you choose, too. That comes at the cost of added weight, swing weight, and less subtlety than I’d like in close, but overall the 9’6″ 6wt Orvis H3F is a fantastic rod that’s worthy of a spot in any angler’s quiver.Įven though this rod is part of the “3F” family, don’t mistake it for a slouch in the power department. Being 9’6″ long, it’s obviously a great tool for high-sticking dead drifts, and is an absolute dream for mending from a drift boat. Whether I had streamers or dries on the end didn’t matter the rod just flat-out performed. But after a month or so spent with the 9’6″ 6wt Orvis H3F, I’ve decided the extra length and weight of this rod is more than worth it.įor starters, this rod will pick up and throw line. Is a 10′ 5wt, for example, worth the extra swing weight just for the reach?Īs with everything in fly fishing, it depends. ![]() ![]() I’ve experimented a lot with rod length in the past year or so, trying to determine how much of a difference it makes for my “usual” fishing circumstances. The first one I reviewed, an 8’6″ 4wt, is still arguably the best 4wt you’ll find on the market today. The various configurations of this rod series I’ve fished have been absolutely stellar. I’ve heaped a ton of praise on the Orvis H3F lately, but with good reason.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |